Operation and management of Refractory Gunning Machine

Refractory Gunning Machine operating procedures
1. gunning machine pipeline installation
2. gunning machine, air pressure machine, water pump
3. Give the wind began to spray stoppage time, the gun pressure adjustment to the required pressure and stable air pressure
4. Give water gun pressure adjustment to the required pressure and stabilize water pressure
5. Finally, feeding, and to ensure the continuity of feed
6. Spray the end of stoppage time to stop feeding, but keep running water machine
7. again without water, but keep gunning machine operation
8. Finally, the compressor stops and gunning machine

Sealed preservation
Airbrush machine is running under high pressure, to maintain a good seal is to ensure that the fundamental gunning machine during normal operation. There are three aspects of the seal is not good reason;
1. Refractory Gunning Machine friction disc wear: Sealed worn friction plate, resulting in dust from the machine gunning spray charging port, so that the work of environmental degradation, increased compressor power consumption. To address these issues should be used to strengthen the lining maintenance, friction plate is installed correctly, it is necessary to ensure the rotation of the gap, but also to ensure the seal needs, regularly check and replace seals.
2. Excessive wear tube burst: in the course of feeding tube length should be minimized to reduce the large bend points to reduce the pressure inside the pipe, reduce the wear rate of the feed tube.
3. The snap interface deformation: bayonet connector bite lax use during and after use should be avoided damage deformed snap interface, otherwise it will increase the pollution of the air compressor power consumption and the environment.